After stitching the boat you only need to glue between the stitches for the boat to keep it's shape. then you remove the stitches and wires and start filleting on the outside. on the inside i used. One of the most fun part is stitching and gluing the hull together. for that i drilled small holes in the mating panels and used cable ties to hold them tight. in those points where there is. Have a look at how the transom is being reinforced. i am using light wood half checked glued with thickened epoxy. this is step 3 of a series of movies illustrating the stitch and glue boat.
Learn how to master the scarf joint technique for plywood boat building. it's easy and fun! this is step 2 of a series of movies illustrating the stitch and glue boat building technique. i have. I now finished construction of the centerline structure. this had to be done carefully as the accuracy of the hull construction will depend upon this. i have attached all mating components to the. Lapstrake/clinker is the method of wooden boat building where the planks overlap rather than butting each other.. while an underlying back bone is needed, the framing can be done after the planking and ribbands may not be needed.. the planks are fastened with rivets, clench nailsor glue where they overlap, resulting in a hull of considerable strength. the tight fit between planks is.
